Jenway 3540 User Manual
Page 12
2.22
Electrode Holder Assembly
The electrode holder requires minimal assembly (refer to the diagram below).
4
1
2
3
Decide on which side of the instrument you require the electrode stand to be
positioned. Align the base plate with the shorter edge to the front of the instrument, so
that the tapered sides match the taper on the instrument.
Screw the rod into the base on the side required. If gripping the rod is difficult an Allen
key or small screwdriver inserted in the 4mm hole at the bottom of the rod enables it
to be tightened further.
Remove the rubber top cap and slide the electrode down the rod while squeezing the
sprung retainer. Replace the rubber top cap.
Fit the electrodes and ATC probe into the holder, use the side clips to keep the
cables tidy.
Adjust the height and rotation of the electrode holder to suit your work station and
sample containers as necessary.