Jenway 3540 - Manual (Page 15)

Section 3
Set Up - General
3.00
General Set Up
The general set up options include instrument wide functions that are relevant for
both pH and conductivity channels. Functions that can be set in these menus are
language, display brightness, GLP options, data logging options, clock, security and
printer set up. Adjustments made to these settings are stored in non-volatile memory
so will not need to be re-entered unless further changes are required. They will also
be retained regardless of the power connection to the instrument.
3.01
Connect the power supply as described in section 2.2.3. It is not necessary to
connect the probes for the set-up procedures.
3.02
Switch on the power at the supply socket; then press the power on/off key on the
instrument.
3.03
The 3540 start up screen is shown for a few seconds followed by the main
measurement
screen with either the pH or conductivity tab highlighted (depending on
which was active when power was switched off).
3.04
Press the right or left arrow keys [ ] to highlight the Set Up tab on the menu bar at
the bottom of the screen. This will open the main Set Up page.
Main Set Up screen
3.05 Press the up or down arrow keys [ ] to move the highlight over the General Set
Up… option. Press the enter key [ ] to open the General Set Up page.
General Set Up Screen
Use the General Set Up flow diagram and General Set Up menu selections on the
following pages to identify the settings that you wish to adjust from their default
values. Then refer to the following paragraphs for further guidance on making these
adjustments.