In-Situ Win-Situ 2000 Operators Manual - Manual (Page 6)

2
0024690 rev. 002 09/00
Service Pack 4 or higher, a serial communications port, 16 megabytes of
RAM, a hard disk, VGA compatible 640 x 480 display, and a Windows-
compatible mouse or other pointing device.
INSTALLING WIN-SITU 2000
Insert the Win-Situ 2000 CD or floppy disk in the appropriate drive of your
computer.
• CD: If the CD-ROM drive is set to Auto-Play, the installation program
will start automatically. If necessary, choose Run from the Windows
Start Menu and type D:\Setup, where D is your CD-ROM drive.
• Floppy disk: Choose Run from the Windows Start Menu and type
A:\Setup, where A designates your floppy disk drive.
Follow the instructions to install the program to your local hard drive. A
shortcut will be created on the desktop:
For more information . . .
How to See page
Start Win-Situ 3
Navigate the Win-Situ screen 8
Connect to a device 4
Set the device clock 5, 15
Take a manual reading 15
Set up a data collection test 25
Give the device a unique name 15
Check the pressure range 11-12
Check the battery & memory capacity 10
Set up to measure water levels 17
Calibrate an MP TROLL for water quality 24
Check the firmware version 10
Set unit preferences 14
SECTION 1: INTRODUCTION