In-Situ Win-Situ 2000 Operators Manual - Manual (Page 22)

18
0024690 rev. 002 09/00
SECTION 5: PRESSURE PARAMETER SETUP
The Parameter Wizard will help you enter the required information.
The choices are discussed below.
3. Click Finish to complete the Wizard. Win-Situ will send the
information to the device and update the display.
Name
A default name is supplied for display in the Navigation tree and test
data files. If you choose, you can enter a custom name.
Display Mode
Select one of the following. Subsequent screens will be tailored to your
choice.
• Pressure Head displays the raw
pressure exerted by the column of
water above the pressure sensor, in
kiloPascals, pounds per square inch,
bars, or kilograms per square
centimeter. If you choose this mode,
click Finish to end the Wizard.
• Depth converts the pressure of the
water column to a depth reading, in
meters, centimeters, feet, or inches.
TIP: To change the units for pressure, depth, or level
readings, select Preferences from the Options Menu.
1
2
Depth