In-Situ RuggedReader Operators Manual for Blue RuggedReader - Manual (Page 15)

15
0055450 rev. 002 10/07 Rugged Reader Operator’s Manual
SECTION 2: GETTING STARTED
5. Insert the tabs on the bottom of the battery door into
the case slots. Make sure the door latch is all the way
to the right and properly aligned. Then close the
battery door.
6. Press firmly on the battery door and slide
the latch to the left to lock it.
7. Reattach the hand strap.
STEP 2: CHARGE THE BATTERY PACK
1. Mount the plug onto the wall charger (if it is not already assembled).
2. Plug the wall charger into an outlet.
3. Plug the other end of the wall charger into the DC
jack on the RuggedReader. The device turns on
after a few seconds, and a flashing red light appears
to signal the device is charging.
4. Charging the RuggedReader for 4.5 hours charges it up to 95%. Let
the device charge for 6 hours to get a full charge.
STEP 3: CALIBRATE THE TOUCHSCREEN
When you first power your RuggedReader, or after a device reset, you will
be prompted to calibrate the touchscreen. Using the stylus, follow the
instructions on the screen.
To protect the touchscreen, we recommend that you apply a screen
protector. See
Protecting the Touchscreen in Section 3.
TIP: Note: After a
few minutes the
device suspends,
and the flashing red LED
turns off, but the device
keeps charging.
➔
➔
➔
Press
here
DC input jack