beautypg.com

Message terminator and message separator – GW Instek GDS-800 Series Programming Manual User Manual

Page 16

background image

GDS-806/810/820/840 Programming Manual

15

For the actual value of the parameter type , you have to enter 0 instead

of “OFF” or enter 1 instead of “ON”.

The following example includes both the header and a value for the parameter type:

:TRIGger:NREJ 0

Parameter values that appeared in this manual are often separated by a vertical

line. This vertical line means the same thing as the word "or," For example, values

for the parameter are

0|1

This is the same thing as saying "0 (off) or 1 (on)" Any single value is a valid

parameter.

Message Terminator and Message Separator

In accordance with IEEE 488.2 standard, this oscilloscope accepts any of the

following message terminators:

z

LF

^

END

Line feed code (hexadecimal 0A) with END message

z

LF

Line feed code

z

^

END

Last data byte with END message

These terminators are compatible with most application programs.

A semicolon separates one command from another when the commands appear on

the same line.