GW Instek SFG-830 User Manual - Manual (Page 44)

SFG-830 p.41
＊SRE Service Request Enable Command
z ＊ESE, followed by a decimal value, sets the bits of the〝Service
Request Enable Register〞which correspond to that decimal value to
1, except bit 6. For all bits except bit 6, a bit value of one shall indicate
an enabled condition. The bit value of one indicates a disabled
condition. The bit value of bit 6 shall be ignored.
＊SRE？ Service Request Enable Query
z Asks for the contents of the〝Service Request Enable Register〞.
The response is a decimal value.
＊STB？ Read Status Byte Query
z Asks for the contents of the〝Status Byte Register〞. The response is
a decimal value.
＊SAV Save Command
z This command followed by a decimal value stores the current
instrument setting into the corresponding memory place. The
contents of the memory is not affected by the command ＊RST or
when POWER OFF the instrument.
＊RCL Recall Command
z This command followed by a decimal value for the memory place call
up and executes the instruments settings stored in that memory
place.