GW Instek SFG-830 User Manual - Manual (Page 22)

SFG-830 p.19
(1) Common Commands of IEEE488.2
Command Function Parameter
*CLS Clear status command Nil
*ESE Standard event status enable command Numerical data
*ESE? Standard event status enable query Nil
*ESR? Standard event status register query Nil
*IDN? Identification query Nil
*OPC Operation complete command Numerical data
*OPC? Operation complete query Nil
*RCL Recall command Integer among 0 ~ 9
*RST Reset command Nil
*SAV Save command Integer among 0 ~ 9
*SRE Service request enable command Numerical data
*SRE? Service request enable query Nil
*STB? Read status byte query Nil
*TST? Self-test query Nil
*WAI Wait-to-continue command Nil
Note : c The range of numerical data is 0 ~ 255.
d For more details, please refer to appendix 1.
(2) Commands of the Instrument
Command Function Parameter
SYSTem:ERR? Check the type of error messages Nil
SOURce:FUNCtion:SINusoid Select sine waves Nil
SOURce:FUNCtion:SQUare Select square waves Nil
SOURce:FUNCtion:TRIangle Select triangle waves Nil
SOURce:FUNCtion:RAMP Select ramp waves Nil
SOURce:FUNCtion:ARBitrary Select arbitrary waves Nil
SOURce:FUNCtion:WAVEform? Check the present waveform Nil
SOURce:FREQuency:SYNThesis Set the frequency of synthetic waves Numeric data
SOURce:FREQuency:SYNThesis? Check the frequency of synthetic waves Nil