GW Instek SFG-830 User Manual - Manual (Page 23)

p. 20 SFG-830
Commands of the Instrument (cont.)
Command Function Parameter
SOURce:FREQuency:CENTer Set center frequency of synthetic waves Numeric data
SOURce:FREQuency:CENTer?
Check the center frequency of synthetic
waves
Nil
SOURce:FREQuency:SPAN Set span frequency of synthetic waves Numeric data
SOURce:FREQuency:SPAN?
Check the span frequency of synthetic
waves
Nil
SOURce:FREQuency:STARt Set the value of the initial frequency Numeric data
SOURce:FREQuency:STARt? Check the value of the initial frequency Nil
SOURce:FREQuency:STOP Set the value of the ending frequency Numeric data
SOURce:FREQuency:STOP? Check the value of the ending frequency Nil
SOURce:SWEep:SPACing Set the method of sweep LINear or LOG
SOURce:SWEep:SPACing? Check the method of sweep Nil
SOURce:MODulation:STATe Enable modulation function ON/OFF or 0/1
SOURce:MODulation:STATe? Check if in modulation mode Nil
SOURce:PHASe:ADJust Set the data of phase Numeric data
SOURce:PHASe:ADJust? Check the data of phase Nil
SOURce:AMPLitude:LEVel Set the value of output amplitude Numeric data
SOURce:AMPLitude:LEVel? Check the value of output amplitude Nil
SOURce:AMPLitude:STATe Get in amplitude mode ON/OFF or 0/1
SOURce:AMPLitude:STATe? Check if in amplitude mode Nil
SOURce:AMPLitude:UNIT Set the unit of output amplitude
VPP, VRMS or
DBM
SOURce:OFFSet:LEVel Set the voltage of offset Numeric data
SOURce:OFFSet:LEVel? Check the voltage of offset Nil
SOURce:OFFSet:STATe Get in bias mode On/OFF or 0/1
SOURce:OFFSet:STATe? Check if in bias mode Nil
SOURce:SWEep:RATE Set the rate of modulation Numeric data
SOURce:SWEep:RATE? Check the rate of modulation Nil
SOURce:FUNCtion:SOURce Set the waveform of modulation 1,2,3,4,5
SOURce:FUNCtion:SOURce? Check the waveform of modulation Nil
SOURce:FUNCtion:AM:STATe Set AM modulation ON/OFF or 0/1
SOURce:FUNCtion:AM:STATe? Check if in AM modulation Nil