GW Instek GDS-2000 series Programming manual - Manual (Page 76)

GDS-2000 Series Programming Manual
76
:TEMPlate:TOLerance
Sets and query the tolerance of auto template.
Before running this command, the oscilloscope has to be initialized as “Auto
Template” mode, please add the command of “:TEMPlate:MODe 1” in order to
change the settings.
Syntax
:TEMPlate:TOLerance
:TEMPlate:TOLerance?
Arguments
is the desired tolerance percentage. The range is from 0.4~40 (or 0.4% to
40%).
Returns
%
Note: Before input any template editing commands, the oscilloscope has to be initialized,
please add the command of “:GONogo:FUNCtion 1” in order to initial the oscilloscope.