GW Instek GDS-2000 series Programming manual - Manual (Page 6)

GDS-2000 Series Programming Manual
6
Computer’s Connection for USB
User may connect the USB device connector of oscilloscope with personal
computer’s USB in order to remote control the oscilloscope via USB interface. This
USB device connector is USB 2.0 full speed compatible.
The connections between oscilloscope and computer are as follows:
I. Connect the USB device connector and computer’s USB port with a USB
cable. The USB cable should be type AB, USB2.0 compliant. User may
order a USB cable from GWInstek, the part number for USB cable is
4242-1041820 (GTL-242 USB cable).
II. Connect the USB connector of type B with oscilloscope’s USB device
connector.
III. Connect the USB connector of type A with computer’s USB port.