GW Instek GDS-2000 series Programming manual - Manual (Page 74)

GDS-2000 Series Programming Manual
74
:TEMPlate:SAVe:AUTo
Save the Auto template. This command is equivalent to pressing the “Save &
Create” (F4) function key of the auto template editing menu.
Before running this command, the oscilloscope has to be initialized as “Auto
Template” mode, please add the command of “:TEMPlate:MODe 1” in order to
change the settings.
Syntax
:TEMPlate:SAVe:AUTo
Note: Before input any template editing commands, the oscilloscope has to be initialized,
please add the command of “:GONogo:FUNCtion 1” in order to initial the oscilloscope.