GW Instek PSM-Series User Manual User Manual

Page 17

PSM-SERIES PROGRAMMABLE POWER SUPPLY

USER MANUAL

⎯ ⎯

z STORE : Save the setting data to one of the memory groups

STORE setting method: Press the function of [STORE], use knob or

number key to input the memory address to save the data.

For example: Store the setting date to the memory address of 01.

Press [SHIFT][STORE] to get into STORE setting, then input

[0][1][ENTER] to complete the Store.

z Rotary Encoder : The wheel knob for number input or function

selection.

The function knob can be used for number input or function selection.

When the knob is used as number input, it should be matched with the

cursor moving keys [<] and [>].

z [<] and [>]: [<] and [>] are cursor moving keys for number input or

function selection.

z LOCAL(GPIB/RS-232) : Clear the Remote Control mode and use the

panel control mode instead. Press [SHIFT][GPIB/RS-232] to GPIB

or RS-232 setting selection.

PSM-SERIES PROGRAMMABLE POWER SUPPLY

USER MANUAL

⎯ ⎯

Press [LOCAL] function can clear Remote Control mode and use panel

control instead. After press [SHIFT][GPIB/RS-232], use knob to select

GPIB or RS-232 and press [ENTER] to confirm the setting. If want to set

to GPIB, use knob to select input address, then press [ENTER] to

complete GPIB setting. If want to set to RS-232, use knob to select input

BAUD rate, then press [ENTER] to complete RS-232 setting.

Remark: When enter GPIB/RS-232 setting, can press again [SHIFT]

[GPIB/RS-232] to leave the function.

For example: Select GPIB communication interface and set the

ADDRESS to 08.

Press [SHIFT] [GPIB/RS-232], use wheel knob to select GPIB and press

[ENTER] to confirm the setting. Then use wheel knob to select [08] and

press [ENTER] to complete GPIB setting.