GW Instek PSW-Series Programming & Command manual - Manual (Page 82)

PSW Series Programming Manual
82
SYSTem:CONFigure:MSLave
Set
Query
Description Sets or queries the unit operation mode. This
setting is only applied after the unit has been reset.
Syntax
Query Syntax SYSTem:CONFigure:MSLave { 0 | 1 | 2 | 3 | 4 }
SYSTem:CONFigure:MSLave?
Note Series mode is only supported for 30V, 80V and
160V models.
Parameter/Return Description
0 Master/Local
1 Master/Parallel 1 (2 units)
2 Master/Parallel 2 (3 units)
3 Slave/Parallel
4 Slave/Series
SYSTem:CONFigure:OUTPut:EXTernal
[:MODE]
Set
Query
Description Sets the external logic as active high or active low.
This setting is only applied after the unit has been
reset.
Syntax
Query Syntax SYSTem:CONFigure:OUTPut:EXTernal[:MODE]
SYSTem:CONFigure:OUTPut:EXTernal[:MODE]?
Parameter 0 Active high
HIGH Active high
1 Active low
LOW Active low
Return Parameter 0 Active high
1 Active low
SYSTem:CONFigure:OUTPut:PON[:STATe]
Set
Query
Description Sets the unit to turn the output ON/OFF at power-
up. This setting is only applied after the unit has
been reset.