GW Instek PSW-Series Programming & Command manual - Manual (Page 79)

REMOTE CONTROL
79
SYSTem:BEEPer[:IMMediate]
Set
Query
Description This command causes an audible tone to be
generated by the instrument. The duration time is
specified in seconds.
Syntax
Query Syntax SYSTem:BEEPer[:IMMediate]
{|MINimum|MAXimum}
SYSTem:BEEPer[:IMMediate]? [MINimum|MAXimum]
Parameter 0 ~ 3600 seconds.
MINimum Sets the beeper time to the minimum (0
seconds)
MAXimum Sets the beeper time to the maximum
(3600 seconds)
Return parameter Returns the remaining beeper duration
time in seconds or returns the maximum
or minimum beeper time in seconds (for
the [MINimum|MAXimum] query
parameters).
Example 1 SYST:BEEP 10
**after a 2 second wait**
SYST:BEEP?
>8
The first command turns the beeper on for 10
seconds. After 2 seconds the SYST:BEEP? query
returns the remaining beeper time (8 seconds).
Example 2 SYST:BEEP? MAX
>3600
Returns the maximum settable beeper time in
seconds.
SYSTem:CONFigure:BEEPer[:STATe]
Set
Query
Description Sets or queries the buzzer state on/off.
Syntax
Query Syntax SYSTem:CONFigure:BEEPer[:STATe] {OFF|ON|0|1}
SYSTem:CONFigure:BEEPer[:STATe]?
Parameter 0 Turns the buzzer off.