GW Instek GBS-1000 Series Programming Manual - Manual (Page 61)

COMMAND SET
61
:MEASure:LRRDelay
Query
Description Returns the delay between the first rising edge of
source1 and the last rising edge of source2.
Same as: Measure key → F1~F5 → F3 (DelayLRR)
Syntax < Long > < Short >
:measure:lrrdelay? :meas:lrrd?
Returns
Before this
command Select the two delay channels before entering this
command: :measure:delay1
and :measure:delay2 . See pagexx.
Example :measure:delay1 1
:measure:delay2 2
:measure:lrrdelay? Select channel 1 and 2
as delay source1/2, and
then measure LRR.
:MEASure:NWIDth
Query
Description Returns the first negative pulse width timing.
Same as: Measure key → F1~F5 → F3 (–Width)
Syntax < Long > < Short >
:measure:nwidth? :meas:nwid?
Returns
Before this
command Select the measurement channel before this
command: :measure:source . See pagexx.
Example :measure:source 1
:measure:nwidth? Select channel 1, then
measure negative pulse
width.