Additel 221A Multifunction Temperature Calibrator User Manual - Manual (Page 68)

________________________________________________________________________________________________________________
61
Figure 10.6 Task View
The detail data will be shown before you run thetask. If you want to
change the parameters of the task, you can edit it by pressing Edit(as
shown in Figure 10.6).
If the task has been calibrated, the parameters cannot be edited, and
then press "Save As" tosave it as a new oneand the parameters will be
editable.
You can press the navigation keysLeft/Right to switch the content in this
page.
Before starting a task, you should ensure the external device is available.
Start the calibration by pressing Enter or AsCal.