Additel 221A Multifunction Temperature Calibrator User Manual - Manual (Page 66)

________________________________________________________________________________________________________________
59
Editing UUT Calibration Data
Then we should set the tolerance and the calibration set points (as
shown in Figure 10.4).
The tolerance should besetcorrectly. Otherwise it will causeundesired
result.
Change the calibration points (2 to 11) by press the navigation
keysLeft/Right, the default set points will be calculated automatically.
The default set points are typical values for calibration. If you want to
change the value of the task, select the task in the task list then press
Edit to make the change.
You can edit the points on the Points Edit page.
Press Enter or Finish completing.
10.3 Delete/Erase Tasks
If you want to free up some memory,space or no longer require certain
tasks, deletetasks from the calibrator's memory as follows:
On the Tasks List page, select the task which you want to delete. Press
Delete,andthe confirmation dialog box will appear. The task and its
calibration data will be deleted permanentlyby pressingEnter
To erase all tasks (and their calibration data), select "Erase All Tasks" in the Task Management page, and press Enter
orSelect
Figure 10.4 Task UUT Calibration Data