Triton FT5000XP Prism NDC Emulation w/XFS Compliance User Manual - Manual (Page 49)

45
P
riSm
tm nDc e
mUlAtion
S
UPerViSor
F
UnctionS
Note: If any options are selected that require devices that are not present
or not configured, the message “DEVICE NOT PRESENT” or “NOT
SUPPORTED” will appear.
To exit supervisor, ensure that the supervisor switch is set to ‘RUN’. Navigate
back to the main menu (
Select
) and press
Ancel
> again. If the supervisor
switch is still in SUPERVISOR, the
Select
menu screen remains and you
will be prompted to switch to RUN mode. At this point, you will still be able
to enter sub-menus (effectively cancelling the exit request). However, if you
set the switch to RUN without entering a sub-menu, the application will exit
supervisor.
3.1 Select Menu
REPLENISH: A sub-menu containing cash and media replenishment and
test functions c
UStomer
(r
Un
) m
oDe
. See the “Replenish Menu” section.
CONFIGURE: A sub-menu containing ATM configuration functions. See
“Configure Menu” section.
ACCESS: A sub-menu containing password access and encryption key
management functions. See “Access Menu” section.
DIAGNOSTIC: A sub-menu containing diagnostics and test functions. See
“Diagnostic Menu” section.
TRANSFER: A function for transferring the supervisor interface to the front
or rear screen. When transferring to the front, “FACIA” will appear on the
rear operator panel and a password prompt will appear on the front customer
screen. The default password is ‘2468’.
EXIT: A function for exiting S
UPerViSor
m
oDe
and returning to the c
UStomer
(r
Un
) m
oDe
. Note that pressing
Ancel
> at the Select menu will have the
same effect.