Triton FT5000XP Prism NDC Emulation w/XFS Compliance User Manual - Manual (Page 23)

19
R
epleniShing
c
aSSetteS
n
ew oR
U
nciRcUlated
n
ote
d
eFectS
 All the conditions listed for
used notes.
 Excessive bowing due to condi-
tions of packing and storing.
 New or uncirculated currency
must be “burst” and fully sepa-
rated prior to loading into cas-
settes.
U
Sed
n
ote
d
eFectS
 Adhesive or “sticky” substances
on the surface of the paper.
 Tears extending more than 1/2”
from the edge of the currency.
 Tears, holes, or missing sections
in the body of the currency.
 Tape on the surface of the cur-
rency used for repairing, patching
or any other purpose.
 Staples, pins, or any other foreign
body attached to the notes.
 Corner folds of a size greater than
1/2” on either axis.
 Two or more notes joined by any
means.
 Excessively crumpled or crinkled.
p
RepaRing
n
oteS
Use the following procedures to pre-
pare notes before inserting them into
a note cassette.
p
RepaRing
U
Sed
n
oteS
 Remove the band around each
bundle of notes.
Removing band.
Removing torn/worn notes.
n
ew oR
U
nciRcUlated
n
oteS
Remove the band around each bundle
of notes. Separate the notes from each
other by:
 Striking the bundle hard against
the edge of a table or similar
object.
 Flipping through each bundle of
notes in both directions at each
end.
 Using a note counter.

Remove foreign objects (e.g. pins,
paper clips, crumbs, etc.).

Remove torn or very worn notes.

Straighten any folded notes.