Triton FT5000XP Prism NDC Emulation w/XFS Compliance User Manual - Manual (Page 35)

31
P
reventative
M
aintenance
r
ePleniShing
r
eceiPt
P
aPer
(Ft5000 XP )
NOTE: This operation must be com-
pleted with the AC power applied to
the ATM.
1. Open the left side and rear service
panels on the cabinet sleeve.
2. If paper remains on the roll, cut
the paper between the roll and the
input to the printer with a pair of
scissors.
3. Press and hold the paper feed
button until the paper clears the
front of the printer.
4. Remove the existing paper roll
or empty spindle (as appropriate)
from the paper support bracket.
5. Unwind about 18 inches from the
end of the new roll of paper. Using
scissors, cut off the excess. Make
sure all the paper that has glue on
it is removed from the end of the
roll.
6. Install the new paper roll on the
spindle. Place the paper roll (w/
spindle) on the paper support
bracket by sliding ends of spindle
on to the bracket. Ensure the paper
feeds from the TOP of the roll!.
** CAUTION **
Do not pull the paper backward
through the printer. This may
leave paper fragments that can
cause paper jams.
Paper feed
button
Paper support
bracket
*IMPORTANT*
Standard thermal and Black
Mark thermal paper have differ-
ent specifications. If necessary,
contact your Triton certified
service provider for ordering
information!