Triton FT5000XP Prism NDC Emulation w/XFS Compliance User Manual - Manual (Page 33)

29
P
reventative
M
aintenance
3. Press and hold the paper feed
button until the paper clears the
front of the printer.
4. Remove the existing paper roll
or empty spindle (as appropriate)
from the paper support bracket.
5. Unwind about 18 inches from
the end of the new roll of paper.
Using scissors, cut off the excess.
Make sure all the paper that has
glue on it is removed from the end
of the roll.
6. Install the new paper roll on the
spindle. Place the paper roll (w/
spindle) on the paper support
bracket by sliding ends of spindle
on to the bracket shown. Ensure
the paper feeds from the TOP of
the roll!
** CAUTION **
Do not pull the paper backward
through the printer. This may
leave paper fragments that can
cause paper jams.
7. Insert the edge of the paper roll
into the printer take-up slot.
Note: Paper feeds over the bar.
The printer will automatically
grip and pull the paper into the
paper path. If the paper feeds
automatically, skip to Step
10. If the paper does not feed
automatically, continue with Step
8.
Paper feed
button