Triton FT5000XP Prism NDC Emulation w/XFS Compliance User Manual - Manual (Page 28)

24
M
odel
Rl/Ft5000 Xp U
SeR
M
anUal w
/p
RiSM
tM ndc e
MUlation
Removing the reject vault. Reject vault ready to open.
Key inserted. Opening lid.
R
eMoving the
R
eJect
c
aSSette
o
pening the
R
eJect
c
aSSette
1. Insert the key into the cassette lock. To unlock the cassette, apply inward
pressure on the key while turning it clockwise to the stop position (ap-
proximately a quarter-turn). Open the cassette by simultaneously pressing
the release button and lifting the lid. Flip the lid back fully (refer to the
figures below).
1. Ensure cassettes are . To remove the reject cassette, (top chan-
nel) grasp the cassette handle with one hand while holding the mechanism
in place with the other hand. Pull the cassette out slightly. Place one hand
underneath to support the cassette as you slide it completely out of the
unit. Place it on a level surface (refer to the figures below).
*IMPORTANT*
If you remove the reject vault with power applied, the terminal will
sense this and automatically reset the rejected note count to ZERO.
Therefore, to ensure an accurate rejected note count NEVER RE-
MOVE THE REJECT VAULT WITH POWER APPLIED WITHOUT
CHECKING FOR AND REMOVING ANY REJECTED NOTES!