Spectra Precision FAST Survey - Manual (Page 64)

English
56
Saving a Configuration
• Tap Equip then GPS Base for a base, or GPS Rover for a
rover.
• Enter all the parameters needed to set the equipment in
the tabs presented in this window.
• Before you tap to load the configuration to the
receiver, come back to the Current tab.
• Tap on the Save button located in the lower part of the
window and then name the configuration (e.g. “Radio” or
“NTRIP”).
• Name the configuration file and tap . This takes you
back to the current tab where the new configuration is now
listed.
Making a Saved Configuration the Current Configuration
• Tap Equip then GPS Base for a base, or GPS Rover for a
rover.
• Select the name of the desired configuration from the
lower list.
• Tap on the Load button.
• Tap Yes to confirm your choice. This restores all the
settings held in this configuration. You may check this by
scrolling all the tabs in the window.
• Tap to load the configuration to the receiver.
Setting the Base
Position With FAST
Survey
Depending on how you chose the base site (is its position
known or unknown?), choose either
From Known Position, for
known position, or From New Position, for unknown position.
Then of the three possible choices, choose the one that suits
your job.