Spectra Precision FAST Survey - Manual (Page 50)

English
42
For your information, this tab shows the name of the
projection selected earlier for the project (see
File>Job
Settings>System). Choosing another projection here would
change the projection used in the job. It is your
responsibility to have the right projection selected on
which the localization process is going to be run.
• Tap on the GPS tab and select your localization methods
for multi-point and one-point localizations. If you choose
“Helmert” as the localization method, the one-point
method selection is grayed.
One-Point or Multi-Point Localization
1. Tap on the Points tab. This tab allows you to define the
reference points used as the input to the localization
process.
For each of the available reference points, you need to
enter the local coordinates and then the WGS84
coordinates, as measured by your equipment.
List of reference points
you want to include in the
localization process
Edits the selected
reference point
Deletes the selected
reference point
Adds a new reference
point to the list
Loads a list of reference points
from a DAT or LOC file
Controls the content of the selected row, in
the points list above, where either the
geographic or local coordinates of the
reference point are displayed
Enables/disables the selected
reference point for/from the
localization process
Saves the list of current
reference points as a LOC or
DAT file
Provides access to Solution
Monitoring screen