End of rover configuration phase – Spectra Precision FAST Survey User Manual

Page 40

English

• Through the

Base ID drop-down list displayed further

down on the screen, select the name of the base

you

want to work with.

If the

Base ID list is blank, tap on

next to it. In the

Name drop-down list, overwrite “” with the
name of the base. Then enter its IP address and IP
port.

NOTE: For each new base entry, first select “”
from the

Name drop-down list, and then enter the base

parameters (Name, Address, Port, Send Rover Position
to Network?). Reciprocally, when you want to delete a
base entry, first select its name from the

Name drop-

down list and then tap on the

Delete button.

• Tap

to validate the new base entry and return to the

RTK tab. The name of that new base is now the current
selection in the

Base ID field.

4. Setting a rover to make a phone call to the base (Direct

Dial):

– Choose the appropriate device so you can set

Network=“Direct Dial”).

– Tap on

next to the

Base ID field to name the base

and enter its phone number. For EPOCH 50 and
ProMark 700, you additional need to specify the type
of corrections delivered by the base.

End of Rover

Configuration

Phase

• After you’ve been through all the tabs, tap

to save all

your settings. The rover will start operating as configured.