Spectra Precision FAST Survey - Manual (Page 20)

English
12
Receiver Tab
Use this tab to set the different operating parameters the
GNSS receiver will use as a base. The table below lists the
parameters you have to set on this tab (and sub-tabs),
depending on the GNSS receiver model you are using.
Additional Information is provided below for some of the
parameters listed above:
• NGS: With this option enabled, FAST Survey will correct
the antenna offset values to get an absolute offset. Keep
it disabled if relative offsets were used in some of the
measurements present in your job.
• Position Rate: 1- or 2-Hz position output rate (irrelevant
to a base).
• Use GLONASS: Remember that activating the Use GLONASS
option in ProMark 220 will be effective only if you have
previously set the
Tracking mode parameter in GNSS
Toolbox to “GPS L1+GLONASS L1” or “GPS/GLONASS
L1/L2”. As for the
Use SBAS and Use QZSS options, only
the last setting made is effective, whether you do it from
GNSS Toolbox or from FAST Survey.
Parameters EPOCH 50 ProMark 220 ProMark 800 ProFlex 800
Antenna Selection NA
Internal/
External
NA •
NGS • • • •
Vertical/Slant Height
Measurement “Vertical”
only
• • •
Antenna Height • • • •
Elevation Mask • • • •
Enable Ports B, F
and Ethernet
•
Position Rate •
Advanced:
Use SBAS
• • •
Use GLONASS • • •
Use Galileo • •
Send file after config NA • • •
NMEA output port • • •
Configure NMEA
Message
• • •
More:
Use QZSS
• • •
Use GPS • • •
Source Datum • • •
Virtual Antenna • • •