Lincoln Electric IM866 POWER REAM - Manual (Page 3)

Safety Information - 3 -
POWER REAM
Before installation and commissioning of the POWER REAM, please read and understand all of the
following safety information. Failure to follow these instructions may result in damage to the equipment or
personal injury.
The POWER REAM is constructed to be safe to operate provided
- Only authorized personnel shall perform installation, commissioning and maintenance and all safety
precautions in these operating instructions shall be observed.
-The accident prevention regulations as well as the safety specifications referenced below are
observed
ANSI/RIA R15.06-1999 Industrial Robots and Robot Systems —Safety Requirements
-For additional safety information see references below
This product shall be integrated into a robot cell with independent safety system by plant engineering.
Install within a secured area, which is only to be entered by qualified personnel for maintenance work or
robot programming.
Before assembling, adjusting or working with the reamer, ensure all equipment in the area is locked out
and disabled.
The torch-cleaning unit is to be used only for torch cleaning within the parameters of its technical
specification.
Do not exceed the specified operating pressure of 80 PSI.
The torch-cleaning unit may only be operated with the cover closed when operated independently.
Keep hands away from unit while in operation.
Keep hands away from the clamp and reamer operating space.
Keep hands away from the wire cutter
Keep eyes away from the sprayer
Shut off the air supply when making adjustment so that the equipment is not pressurized.
Additional fittings or accessories that are not offered from the manufacturer may only be installed with the
approval from the manufacturer.
Do not use the reamer with corrosive or aggressive vapors or liquids without first obtaining approval from
the manufacturer.
Ensure that there is nothing in the reamer unit when shutting down the system.
Warning and instruction labels from the unit are not to be removed or defaced.
For additional safety information, refer to the following publications:
ANSI STANDARD Z49.1, SAFETY IN WELDING AND CUTTING,
American Welding Society, 550 LeJeune Rd. P.O. Box 351040, Miami, FL 33126
ANSI/RIA STANDARD R15.06-1999 Industrial Robots and Robot Systems —Safety
Requirements
American National Standards Institute, 1430 Broadway, New York, NY 10018
Canadian Standards Association; Z434-03 Industrial Robots and Robot Systems – General Safety
Requirements.
5060 Spectrum Way, Mississauga, Ontario, L4W 5N6, CANADA