Lincoln Electric IM866 POWER REAM - Manual (Page 26)

Parts Replacement - 26 -
POWER REAM
Clamp Cylinder Replacement
Disconnect air and electrical supply.
Loosen (6) button head cap screws,
item 1, to remove rear cover.
Remove (6) socket head cap
screws, item 2, to remove top
cover.(3/16‖ hex drive).
Disconnect hose 121 and 122,
item 3, from cylinder in-ports.
Remove reed switch, item 4, from
cylinder.(5/64‖ hex drive)
Remove (2) #10-24 flat head socket
cap screws, item 5, to remove
wedge plate. (1/8‖ hex drive)
Unfasten cylinder rod, item 6, from
T-nut. (3/8‖ wrench)
Loosen and remove cylinder nut,
item 7, (1 1/8‖ wrench)
Remove cylinder, item 8.
Follow steps in reverse order to
reassemble unit.
Apply medium strength threadlocker
to item 5, 6 and 7.
Check the position of
reed switch, item 4. The led
should be on when the clamp is
open with electrical supply
connected.
6
8
1
4
5
3
2