Elitegroup G730 - Manual (Page 75)

61
Installing VGA Display Drivers for Win2K/ME/XP
This section describes the operation and installation of VGA
display software drivers supplied on the Driver Utility CD-
ROM that is shipped with your computer.
1. Insert the CD-ROM Driver into your CD-ROM drive.
2. Click “Start” and Select “Run”.
3. Type the following:
D:\Driver\VGA\Win2K\Setup.exe or
D:\Driver\VGA\WinME\Setup.exe or
D:\Driver\VGA\WinXP\Setup.exe (If D is not your CD-
ROM drive, substitute D with the correct drive letter).
4. Click on “Setup” to begin the Installation Wizard.
5. Follow the Wizard’s on-screen instructions to complete the
installation. Restart the system.
Intalling the Audio Driver for Win2K/Me/XP
To install the audio driver you must first remove the currently
installed driver.
1. Insert the CD-ROM Driver into your CD-ROM drive.
2. Click “Start” and Select “Run”.
3. Type the following: D:\Driver\Audio\Setup.exe (If D is not
your CD-ROM drive, substitute D with the correct drive
letter).
4. Click on “Setup” to begin the Installation Wizard.
5. Follow the Wizard’s on-screen instructions to complete the
installation. Restart the system.