Elitegroup G730 User Manual

Page 38

1. Push the CD-ROM eject button on the CD drive door.

Gently pull the tray all the way out.

2. Carefully lift the CD-ROM by the edges and make sure the

shiny surface is face down (the side with no writing on it).
Carefully insert the CD-ROM onto the tray. Push the CD-
ROM down gently so that it snaps onto the center ring.

3. Push the tray back into the drive.

To remove a disk, do the following:

1. Check the LED display and make sure that the computer is

not accessing the CD-ROM drive.

2. Push the eject button and pull the tray all the way out.

3. Carefully pick up the CD disk by the edges and – while

pressing down on the center ring – remove the CD-ROM
from the tray.

NOTE:

Do not insert any foreign objects into the disc

tray. If you experience difficulty when ejecting the CD disk
tray, stretch a paper clip (or use a pin or a thin metal rod)
and insert it into the emergency eject hole located on the
right side of the front panel. The CD disk tray should eject
immediately. This procedure can also be used to remove
a CD from the drive when the Notebook is powered off.