Elitegroup G730 - Manual (Page 40)

26
when a PC card is inserted. When you eject a card, the
computer will emit a high tone followed by a medium tone.
You can insert and remove a PC card whether the computer is
turned On or Off.
Follow these instructions to insert a PCMCIA card:
1. Hold the PCMCIA card with the arrow side up and the
connector side toward the socket.
2. Align the card connectors with the socket and carefully
slide into the socket until it locks into place. The system
will beep once to indicate that it has detected the PC card.
To remove a PC card push the eject button, the button will pop
out, push the button again to eject the PCMCIA.
NOTE: When inserting a Type II PC card, make sure
the connector is inserted in the socket. Before ejecting a
PC card, ensure that it is not being accessed by the
System.
For example, if the message “Write protect error writing
Drive x” is displayed, the user has to change the write
protect switch setting on the memory card. To change the
switch setting, (a) eject the card, (b) change the switch
setting, and (c) re-insert the card.
CAUTION: Always disconnect all telephone lines from
the wall outlet before servicing or disassembling this
equipment. To reduce the risk of fire, use only No. 26
AWG or larger telecommunication line cord.
Power Saving Modes
This section contains information on the Notebook’s power
system, including the AC Adapter, the battery system,
recharging the battery, and tips for conserving battery power.