Rice Lake Condec UMC600 - Manual (Page 39)

36 UMC600 Installation Manual
4.7.3 Standard Serial Configuration
The Serial I/O option allows standard serial output ports, configured in parameter 14 of the configuration mode, and
options OP3 (time and date), OP5 (tag, ID, counter), and OP4 (accumulator), to be modified and imported into the
serial output data stream. The following table lists configuration parameters in 14 and option modes that are
associated with the customized print
.
Table 4-14. Standard Serial Configuration
4.7.4 Option 7 Configuration
Option 7 configuration allows the user to create or edit files. The following table illustrates the option 7
configuration parameters.
Parameter Function Custom Print
14. Port 1 mode selection (OFF, SI, dU) Port 1 files 7.1 – 7.4 set for simplex or duplex mode.
14.1 Net mode (Gtn/net) multi line (Gtn) or
single line net data print only. This selection is not applicable to the custom print.
14.2 Print delay – off, 1, 2, 3, 4 second delay. Code 700 delays serial transmission for number of seconds
selected in 14.2.
14.3 Port 1 mode (off/Co/dE) set for continuous
or demand Sets port 1 for Co or dE custom print.
14.4 Baud rate selection for Port 1 Port 1 custom print baud selection.
14.5 Port 2 mode (off/Co/dE) set for continuous
or demand Port 2 files 7.5 – 7.8 set for simplex or duplex mode.
14.6 Baud rate selection for Port 2 Port 2 custom print baud selection.
Options
OP3 Time/Date setup Codes 400 to 402 brings time and date into the serial data.
OP4 Accumulator setup Codes 230 to 233 total data.
OP5 Tag mode setup
Identification number setup
Ticket number (counter) setup Code 502 – two digit address code.
Codes 503 and 504 – ID number codes
Codes 510 and 511 – ticket number codes.
Option Prompt Display Interpretation
All Off ------- Mode not enabled (options 1 through 11 off)
OP.7 OP.7 oF
OP.7 on Custom print option
off option disabled
on option enabled
7.1 – 7.8
oFF
on Main print files 1 through 8
Selected file disabled (default printout)
Selected file enabled (custom printout)
7.9 – 7.16
oFF
on Macro files 1 – 8
Selected file disabled
Select file enabled
7.17
oFF
on Delay print file
Disabled
Enabled – print command delayed until data is out of motion
7.18
oFF
on Port 1 demand print inhibit
Disabled
Enabled – the print key, remote print (TB3-10), and auto batch (BAT2) print command are
inhibited from executing a demand print out of port 1