Rice Lake Condec UMC600 - Manual (Page 25)

22 UMC600 Installation Manual
4.0 Options Configuration
The UMC600 offers a selection of optional features that
are available in the configuration of the indicator. The
options setup mode allows the operator to expand the
capabilities of the indicator. The available features are:
• Option 1 - Expanded resolution
• Option 2* - Analog output
• Option 3 - Time and date
• Option 4 - Accumulator
• Option 5* - Local area network\tag\id\counter
• Option 6 - Five-point linearization
• Option 7 - Smart serial I/O
• Option 8* - Analog output relay
• Option 9 - Keyboard lockout
• Option 10 - Setpoints
• Option 11 - Remote Input
NOTE: *Options 2, 5, and 8 require additional
hardware support. Options 1 through 11 are currently
available in the standard EPROM version 15.
To access digital option configuration, close switches
SW1-2 and 3 (Figure 4-1). Press and hold the
ENT key
until OPtion appears on the display. If the option mode
is not enabled (all options turned off), dashes appear
across the display (
- - - - - ).
Figure 4-1. Close Switches SW1-2 and 1-3 for Option
Configuration
In the option mode, primary function keys ( ZERO ,
GROSS/NET , etc.) operate as secondary function keys
(Figure 4-2).
Figure 4-2. Front Panel Keys with Alternate Functions in
Options Menu
Use the ZERO key to select options 1 through 11 or the
TARE RECALL key to scroll backward through the
options. To enable a selected option, use the
GROSS/NET key.
Some options, once enabled, may have an option
submenu available. Use the
TARE key to access the
option submenu. To make parameter selections in the
option submenu, use the
lb/kg CONV key. Display
prompting is provided in each case.
Key Functions Summary
Use the list below (Figure 4-3), as a quick reference
when selecting and configuring the options.
Figure 4-3. Quick Key Functions
1
6
2
7
3
8
4
9
5
0
CE
ENT
TARE
RECALL
ZERO NET
GROSS TARE lb/kg
CONV PRINT
1 SET
POINT
2 SET
POINT
CAPACITY 600 x 0.1
ZERO
NET
GROSS
lb
kg
MOTION
DEAD LOAD (3)
CONF (2)
CAL (1)
3 4 2 1
OPEN
NORM
1
6
2
7
3
8
4
9
5
0
CE
ENT
TARE
RECALL
ZERO NET
GROSS
TARE lb/kg
CONV
PRINT
1 SET
POINT
2 SET
POINT
CAPACITY 600 lb. X 0.1
ZERO
NET
GROSS
lb
kg
MOTION
M O D E L
700
1 SET
POINT
1 2 4 5
ENABLE
DISABLE
OPTION
MENU
PARAMETER
SELECT
SELECT
OPTION
ZERO
TARE
RECALL
1
6
2
7
3
8
4
9
5
0
CE
ENT
ZERO – Increments option number
NET/GROSS – Turns options ON/OFF
TARE – Steps through subparameters or functions as
ENTER for numeric changes
UNITS – Selects subparameters or digit position/decrements
digit for numeric changes
PRINT – Increments digit for numeric entries
TARE RECALL – Provides backstep in configuration mode
0 – 9 – Used to enter numeric values directly,
including ZERO/SPAN values in Option 2
or TIME/DATE in Option 3 mode
NET
GROSS
TARE
lb/kg
CONV
PRINT
ZERO