PreSonus StudioLive Remote - Manual (Page 59)

55
Addendum for
StudioLive Mixers
Ov
er
view
Univ
ersal
Con
trol and VSL
StudioLiv
e
Remot
e
Tr
oubleshooting
QMix 4
QMix
Settings Page 4.5
Wheel of Me Controls the Level of the Me Channels
The Wheel of Me increases or decreases the level of your Me Channels as a
mix relative to the rest of the channels. If you increase the level of your Me
Channels beyond the top level, the rest of the channels will decrease in
volume.
On either side of the Wheel of Me, you will find Me and Band Mix
Indicators. These level displays show the balance between the Me
channels and the Band channels. The Band channels consist of any
channels not identified as Me channels. These indicators will adjust
automatically as you move the Wheel of Me up or down.
4.5 Settings Page
To open the Setting page, tap on the Settings button on the Aux Mix
page or Wheel of Me page. From the Settings page, you can customize
your QMix scrolling and create custom names for each channel and
aux mix.
Scroll by Page Scrolls through Channels by Page.
When the Scroll by Page option is enabled, the mixer will scroll through
channels by entire pages, rather than by individual channels. Turning this
option off will allow you to scroll one channel at a time, offering more
granular control.
Peak Hold Metering Displays the Last Signal Peak.
When Peak Hold Metering is enabled, each meter in QMix will continue to
display the most recent signal peak. This allows you to keep an eye on
how loud each channel’s signal is averaging.
Channel Naming Creates Custom Names for Channels, Auxes, and Subgroups.
To create a custom name for any channel, aux, or
subgroup (16.4.2 and 24.4.2 only) in your mix, simply
tap on the text field next to it. This will launch the
iPhone/iPod touch keyboard. After you have entered
the new name, tap the Done button. The default name
will be replaced with the new custom name in SL
Remote, VSL, and QMix.
Note: Channel Naming can be disabled in
Universal Control. If you are unable to change
channel names from QMix, verify your device’s
permissions in the Setup tab in Universal Control.