PreSonus StudioLive Remote - Manual (Page 41)

37
Addendum for
StudioLive Mixers
Ov
er
view
Univ
ersal
Con
trol and VSL
QMix
Tr
oubleshooting
StudioLive Remote 3
StudioLiv
e
Remot
e
Overview Page 3.3
Channel Controls: Select Selects Channel for Fat Channel Zoom and Portrait View.
When no Microview has been selected for Fat Channel Zoom, the channel
Select buttons merely display the channel number or name, if one has
been entered into the Scribble Strip in VSL or in the Channel Name setup
in SL Remote or QMix. See Sections 2.5.2, 3.6, and 4.5.
Once Fat Channel Zoom is launched, the channel Select buttons
become active, and you can use them to select another channel
so that you can view its zoomed Fat Channel settings.
Channel Controls: Pan Controls the Panning for Each Channel.
To pan a channel, tap and hold anywhere on the Pan control
and then slide your finger right or left, while maintaining
constant contact with the iPad screen. These controls
correspond directly to those in VSL and on the StudioLive.
POWER USER TIP: The Pan control supports off-axis movement. Once you
have pressed a Pan field to select it, you can slide your finger anywhere in the
screen and make a side-to-side movement to control the pan position.
The pan position is displayed numerically in the Channel Select
field while the Pan control is being adjusted in SL Remote.
Channel Controls: Mute Controls the Mute for Each Channel.
To mute a channel, tap its Mute button. The Mute button will turn red,
indicating that the channel has been muted.
Channel Controls:
Fader and Metering
Controls the Level for Each Channel and Displays Each Channel’s Metering.
To control the volume of a channel, tap the fader and move your finger up
or down while maintaining constant contact with the iPad screen.
POWER USER TIP: The fader supports off-axis movement. Once you have
touched a fader to select it, you can slide your finger anywhere in the
screen and make an up/down movement to control the fader.
The fader position is displayed numerically in the Channel Select field.
POWER USER TIP: As with VSL, the fader position set in StudioLive Remote is the level
that you will hear. To sync the physical faders on your StudioLive with StudioLive Remote,
press the Locate button on your mixer. While in Locate mode, the physical faders on
your StudioLive will not be active, so you can adjust them without any changes in
level. VSL gives you the option to have Fader Locate mode engage automatically when
a fader is adjusted remotely. For more information, please see Section 2.5.6.
To the left of the fader, you will see the meter for the channel. The meter
will follow the meter mode selected on the StudioLive or from VSL. The
meter mode cannot be changed from SL Remote.