PreSonus StudioLive Remote - Manual (Page 19)

15
Addendum for
StudioLive Mixers
Ov
er
view
StudioLiv
e
Remot
e
QMix
Tr
oubleshooting
Universal Control 1.6 with VSL 2
Univ
ersal
Con
trol and VSL
VSL: Virtual StudioLive 2.5
2.5.2 VSL: Overview Tab
At the top of the VSL window, you will see four tabs: Overview, Fat
Channel, GEQ, and Setup. The Overview tab provides you with a
complete graphical representation of your StudioLive. As you adjust
parameters on the StudioLive, you will notice that the VSL overview
is also updated. If you use your mouse to adjust a parameter in VSL,
the StudioLive will be updated remotely. It is important to remember
that every button, knob, slider, and fader on the VSL corresponds
directly to a button, knob, slider, or fader on your StudioLive.
The graphic above identifies each controller labeled with its
corresponding control on the StudioLive and can be used as a
map to quickly learn how to navigate the Overview tab.
Aux Send View
VSL provides two views for your StudioLive aux outputs and FX
buses. The Aux Send view gives you an overview of the send levels of
every channel on your StudioLive to every aux output and FX bus.
Clicking on the arrow button will collapse the auxes,
allowing you to view channel faders and the microviews
at the same time on lower-resolution screens.
Power User Tip: To quickly set up an aux mix, use your mouse to set the send level for Channel
1. Right-click on the Channel 1 send level and sweep your mouse across the other channel
sends for that aux. The send level will be copied to every other channel for that aux.
FireWire Return
Digital Out
Phantom Power
Phase Reverse
High Pass Filter
Subgroup Assign
Main Bus Assign
Gate Microview
Compressor Microview
EQ Microview
Aux Send Levels
FX Send Levels
Pan Control
Channel Select
Channel Solo
Channel Mute
Scribble Strip
Channel Level
Channel Meter
Stereo Link
Meter Mode
FX Type Menu
Focus GEQ
GEQ Assign
Focus GEQ
Enable GEQ
Display Browser
Talkback
Copy Mix