PreSonus StudioLive Remote - Manual (Page 27)

23
Addendum for
StudioLive Mixers
Ov
er
view
StudioLiv
e
Remot
e
QMix
Tr
oubleshooting
Universal Control 1.6 with VSL 2
Univ
ersal
Con
trol and VSL
VSL: Virtual StudioLive 2.5
2.5.6 VSL: Setup Tab
The Setup tab allows you to customize VSL and your StudioLive,
route your Auxiliary FireWire inputs (StudioLive 16.4.2 and
24.4.2 only), route your Flexible inputs (StudioLive 16.0.2
only), set up MIDI Control mode (StudioLive 16.0.2 only), and
enable or disable functions on connected iOS devices.
Auxiliary Inputs Router Patches Available Inputs and Buses to Auxiliary FireWire Inputs (16.4.2 and 24.4.2 only).
The StudioLive 16.4.2 and 24.4.2 mixers allow you to route to a computer
the input channels and any 16 of 19 (16.4.2) or 8 of 23 (24.4.2) buses and
other inputs. This is done via the Auxiliary Inputs Router on the Setup tab.
To route FireWire Sends 17-32 (16.4.2) or 25-32 (24.4.2), first decide which
buses and inputs you would like to record in addition to your input
channels. Once you’ve determined your input pairs, simply patch them to
a stereo pair of auxiliary inputs of your choice. Remember, all of these
buses and inputs are automatically set to send their signals post-Fat
Channel dynamics and post-EQ (where applicable). The inputs and buses
selected in the Auxiliary Input Router will be displayed in your recording
application with the name of their routing.
For instance, the routed pairs in the picture would translate as
the following chart in your host recording application:
PHYSICAL SOFTWARE
Main Mix Left Auxiliary In 25
Main Mix Right Auxiliary In 26
Subgroup 1 Auxiliary In 27
Subgroup 2 Auxiliary In 28
Subgroup 3 Auxiliary In 29
Subgroup 4 Auxiliary In 30
Aux Send 3 Auxiliary In 31
Aux Send 4 Auxiliary In 32
The Auxiliary Inputs Router also allows you to designate a specific bus
to the S/PDIF output, as well as enabling you to select which stereo
pair will be recorded on the Auxiliary Stereo Track in Capture. When the
StudioLive is not connected to a computer, the S/PDIF output can be
routed using the System menu. However, when your StudioLive is synced
to your computer, you can route any of the 19 or 23 (depending on your
mixer) available buses to the S/PDIF output by routing them to FireWire
sends 31 and 32. In addition to being available for recording via Aux
In 31 and Aux In 32, these sends are normalled to the S/PDIF output.
As previously mentioned, if Smaart Spectra tools are engaged, VSL will
take control of Auxiliary Inputs 29 and 30. When VSL has control, these
inputs will be grayed out.