Yokogawa Value Series FX1000 - Manual (Page 78)

2-65
IM 04L21B01-64EN
Configuring the FX1000
1
2
3
8
Index
2.7 Sending the Setup Data to the FX
This can only be performed on FXs that have a communication interface (/C2, /C3, or
/C7 option). You cannot send data while the FX is performing memory sampling or math
computations.
Setup Data That Is Sent
Address Setup Data
When settings that deal with communication (hereinafter referred to as “address
settings”), such as IP addresses, are changed, the data for those settings is sent
separately from other setup data. A FX that receives address setup data restarts
automatically and begins operating with the data that has been sent.
The following items are address settings:
• The [TCP/IP] and [Server functions] settings under [Ethernet].
• The [Serial] settings under [Serial].
Setup Data Other Than the Address Setup Data
Other setup data is sent together.
Sending Address Setup Data
1. Select [Comm.] - [Partial Transfer] - [Address Settings] from the menu bar.
The [Network] dialog box appears.
2. Enter the parameters, and click the [OK] button.
The [Store] dialog box appears.
3. Click [OK].
Data transfer starts. A message appears to indicate when data transfer has stopped. Click
[OK] to close the message. The data that you send is enabled after the FX restarts.
Note
After you change the address, the address that is sent is recorded as the retry destination. The
next time you open the [Network] dialog box, the address appears as the initial value.