Yokogawa Value Series FX1000 - Manual (Page 35)

2-22
IM 04L21B01-64EN
Trend
• Display Update 2nd Interval
Enabled when [Trend Rate Switching] is turned [ON] under [Environment] - [Detail
Setting] in the [Basic Setting] tab. Select a rate from the list.
The selectable 2nd intervals are the same as those for Trend interval.
• Direction
Set the display direction of the trends to [Horizontal], [Vertical], [Wide], or [Split].
• Trend Clear
Settings Description
ON Clears the displayed waveform when the memory sampling is started.
OFF Does not clear the waveform when the memory sampling is started.
• Message direction
Set the display direction of messages to [Horizontal] or [Vertical]. When the trend is
set to Vertical, the message direction is fixed to [Horizontal].
• Scale Digit
Select the [Normal] or [Fine].
Fine If the scale value is two-digit display, it can be changed to three digits. For
example, if the scale range is “49.0 to 51.0,” the scale values are displayed
using 3 digits as shown below.
• Value Indicator
The current value is displayed as a mark or a bar graph.
• Trend Line
Set the line width of the trend in dots (1 to 3).
• Grid
Select the number of grids to be displayed in the waveform display area of the trend
display.
Settings Description
4 to 12 Displays a grid that divides the display width into 4 to 12 sections.
Auto Displays the same number of grids as the number of scale divisions of the
first assigned channel of the group.
2.5 Entering General Settings