Yokogawa Value Series FX1000 - Manual (Page 24)

2-11
IM 04L21B01-64EN
Configuring the FX1000
1
2
3
8
Index
Moving Average
To use the moving average, select the sampling count [Times] (2 to 400).
Tag
You can use the tag instead of the channel number to be displayed on the screen.
This can be selected when [Tag] is [Tag] under [Detail Setting] in the [Basic Setting] tab.
You can enter tags using up to 16 characters.
Memory Sampling
Turn [ON] (sample) or [OFF] (do not sample).
Zone (Zone L and U)
You can select the range of the screen in which the waveform of each channel is to be
displayed.
Specify positions (%) on the display scale for the upper and lower limits.
The conditions for setting the zones are as follows:
• Range: 0% to 100%
The lower limit L must be less than the upper limit
• The difference between the lower and upper limits is at least 5%.
Graph
For details, see section 5.7 in the FX User’s Manual.
Scale display position
Select the scale display position on the trend display from 1 to 6. Select [OFF] if you do
not wish to display the scale.
Scale divide position
Select the number of main scale marks on the trend display from 4 to 12 and C10.
If you select [C10], the scale is equally divided into 10 sections by main scale marks, and
scale values are indicated at 0, 30, 50, 70, and 100% positions.
This setting is not applied to any channels that are set to [LogType1] or [LogType2].
Bar display position
Select [Normal], [Center], [Lower], or [Upper].
Bar divide number
Select number of divisions of the scale on the bar graph display.
2.3 Setting the Measurement Channels