Yokogawa Value Series FX1000 - Manual (Page 43)

2-30
IM 04L21B01-64EN
Event Data
Event related settings are enabled when [Data Kind] is set to [E+D] or [Event] in [Basic
Environment] under [Environment] in the [Basic Setting] tab.
Sample rate
Select the data recording interval from the available settings. See the description for “Data
length” below. You cannot specify a sampling rate that is faster than the scan interval.
Mode
Settings Description
Free Records data continuously.
Single Records data when the trigger condition is met.
Repeat Records data each time the trigger condition is met.
Data length
Select the size of a record data file. The recorded data is divided by the file size
specified here. The available data lengths vary depending on the number of memory
sampling channels and the Sample rate setting.
Sample rate 1 125 ms 250 ms 500 ms 1 s 2 s
Selectable range
of data length
10 min to
1 day
10 min to
2 days
10 min to
3 days
10 min to
7 days
10 min to
14 days
Sample rate 1 5 s 10 s 30 s 1 min 2 min
Selectable range
of data length
10 min to
31 days
10 min to
31 days
1 hour to
31 days
1 hour to
31 days
1 hour to
31 days
Sample rate 1 5 min 10 min
Selectable range
of data length
1 hour to
31 days
1 hour to
31 days
1 You cannot choose an interval that is faster than the scan interval.
Pre-Trigger
Specify the range when recording data before the trigger condition is met. Select the
range as a percentage of the data length from 0, 5, 25, 50, 75, 95, and 100%. If you do
not want to record the data existing before the trigger condition is met, select 0%.
Trigger Signal Key
Select [ON] if you want to activate the trigger using key operation.
2.5 Entering General Settings