Yokogawa digitalYEWFLO (DY) - Manual (Page 90)

PARAMETER SETTING/CONFIGURATION
IM 1F2B4-01-YIA
Page 85
As shown on As shown on TBL As shown on As shown on TBL
the BT100/BT200 TBL indicator/ the BT100/BT200 TBL indicator/
totalizer display totalizer display
B02 2 E03 E3
B03 3 F01 F1
B10 10 F02 F2
B11 11 G01 G1
B52 52 G02 G2
B53 53 G03 G3
C01 C1 G04 G4
C02 C2 G05 G5
C09 C9 G06 G6
D01 d1 H01 H1
D02 d2 H02 H2
D03 d3 H03 H3
D05 d5 H04 H4
D06 d6 H05 H5
E01 E1 H06 H6
E02 E2 H07 H7
5.1.1 Display contents in display section
Available modes include normal, setting and alarm number display. Each is described in detail in
table 5.1.3.
No. Mode (status)
name
Key
operation
Display contents
1 Normal mode --- A mode in which instantaneous flow rates or totalized values
are displayed. Display content is usually selected either in
display content selection mode or by setting parameters via
BRAIN™ communication.
2 Setting mode SET In this mode, parameter contents are confirmed or data is
updated using the setting section. The mode is changed to
this mode when
SET is pressed in normal mode.
3 Alarm number
display mode --- This mode is overlapped when an alarm is occurring in
normal mode. The alarm number presentation to indicate
alarm contents (about 2 secs) and the normal data display
(about 4 secs) are repeated alternatively.
Table 5.1.4: Display Mode Number List
•Normal Mode
The normal mode will display the instantaneous flow rate or totalized flow. The six available
display modes are shown in Table 5.1.1.
To access the Setting mode press the SET key which transfers to the “setting mode” status.
The left two digits indicate the parameter item number and the four digits to the right of the “ : “
indicate the parameter data content.