Yokogawa ADMAG AXF - Manual (Page 95)

IM 01E20D01-01E 6-33
6. OUTLINE
᭹ Table of Optional Specifications (Size 500 mm (20 in.) to 2600 mm (104 in.))
AXF***W
-N
Submersible
AXF***G-N
General
Applicable Model
Item Specifications
For District Heating
and Cooling or
Condensation-proof
Urethane resin potting is applied in the terminal box of a remote flowtube. Select JIS G1/2 for the electrical
connections. 30-meter dedicated and excitation cables are pre-wired and waterproof glands with union joints are
attached at factory.
᭺ – DHC
User-specified Signal
and Excitation Cable
Length
Available for the submersible type and a model with optional code DHC. The cable length is limited up to 200 meters
when combined with an AXFA11 converter. Following “L,” specify the cable length in three digits as a multiple of 1
meter (e. g., 001, 002, or 005) for a length up to 5 meters, or as a multiple of 5 meters (i.e., 005, 010, 015, or the like)
for a length of 5 meters or more. If this optional code is not selected, a 30-meter length cable is attached.
᭺ ᭺ L***
Mass Unit Setting The flow rate span, transmission pulse weight, and totalizer display pulse weight can be set in terms of mass unit.
Specify the density of the process fluid when ordering in addition to the mass flow rate span, transmission pulse
weight (for mass unit), and totalizer display pulse weight (for mass unit).
When ordering a remote flowtube, parameters for 'Mass Unit Setting' will be set in the corresponding converter before
shipment.
1. Density
a. Available density Numerics:
Specify the numeric within the value of 500 to 2000 kg/m 3 , 4.2 to 16.7 lb/gal, or 31.2 to 124.8 lb/cf. And it can be
up to five digits, to a maximum of 32000 ignoring the decimal point. A fraction is limited to the fourth decimal place.
b. Available density units: kg/m 3 , lb/gal, lb/cf
Example: A water density is about 1000kg/m 3 . In this case specify “1000kg/m 3 ”.
However a density is changed by temperature. Specify the actual density.
(The 1000kg/m 3 is equivalent to 8.345lb/gal and 62.43lb/cf.)
2. The mass flow rate span, transmission pulse weight, and totalizer display pulse weight
a. Available density Numerics:
Specify the numeric within the value of 0.0001 to 32000. And it can be up to five digits, to a maximum of
32000 ignoring the decimal point. A fraction is limited to the fourth decimal place.
b. Mass Units Available mass units: t, kg, g, klb, lb
Available time units: /d, /h, /min, /s
Note1: In case of specifying the mass flow span, calculate the volumetric flow span by the setting density, and specify
the available value in the mass flow span.
Note2: In case of transmission pulse weight and totalizer display pulse weight, specify the mass unit which was
specified as the flow unit.
᭺ ᭺ MU
G3/4 Female
Waterproof Glands
Waterproof glands for G3/4 conduits or flexible tubes are attached to the electrical connections. Available only for JIS
G1/2 female electric connections.
᭺ – EW
Direction Change of
Electrical Connection (*1)
+90 degrees rotated terminal box to change the direction of the electrical connection. Available for 1000 mm
(40 in.) and smaller sizes.
᭺ ᭺ RA
Material certificates are provided for pipe, electrodes, grounding rings, and flanges. ᭺ ᭺ M01
+180 degrees rotated terminal box to change the direction of the electrical connection. Available for 1000 mm (40 in.)
and smaller sizes.
᭺ ᭺ RB
–90 degrees rotated terminal box to change the direction of the electrical connection. Available for 1000 mm (40 in.)
and smaller sizes.
᭺ ᭺ RC
Waterproof Glands Waterproof glands are attached to the electrical connections. Available only for JIS G1/2 female electric connections. ᭺ – EG
Waterproof Glands
with Union Joints
Waterproof glands with union joints are attached to the electrical connections. Available only for JIS G1/2 female
electric connections.
᭺ – EU
Stainless Steel Tag
Plate
Screwd JIS SUS304 (AISI 304 SS/EN 1.4301 stainless steel equivalent) stainless steel tag plate for size 1100 to 2600
mm, or a pendant tag plate of JIS SUS304 is provided for size 500 to 1000 mm. Choose this option when a SS tag
plate is required in addition to the standard nameplate with the tag number inscribed on it.
Dimension (Height ϫ Width): Appr. 12.5 (4.92) ϫ 40 (15.7) mm (inch)
᭺ ᭺ SCT
Material Certificate
Standard
ϩ90-degree rotation ϩ180-degree rotation Ϫ90-degree rotation
Optional Code RC Optional Code RA Optional Code RB
Remote Flowtube
Electrical
Connection
Electrical
Connection
*1:
T26-5.EPS
Code
Remote
Flowtube
Remote
Flowtube
᭺: Available –: Not available