Diagnostics menu, P 6.7, Factory-diagnostics – Watlow Series 988 User Manual

Page 97: Reaching the diagnostics menu, No] [`yes, Off] [out1] … [out4

WATLOW Series 988 User’s Manual

6.7

Factory Menus, Chapter 6

Factory-Diagnostics

Reaching the Diagnostics Menu

❷ Use the Up-arrow > key to step from
the Panel Lockout Menu [PLOC] to the
Diagnostics Menu [diag].

❶ Press the Up-arrow > and Down-arrow
< keys together and hold until the
[`SEt] prompt appears in the lower dis-
play. Press and hold again until the [Fcty]
prompt appears in the lower display.

MODE

Enter your settings,
from the controller's
upper display.

MODE

[date]

[SOft]

[Sn--]

[AMB]

[Acnt]

[`gnd]

[cnt1]

[cnt2]

[ity1]

[ity2]

[Oty1]

[Oty2]

[Oty3]

[Oty4]

[dISP]

[tout]

[OPLP]

Factory Ship Date

Software Revision

Serial Number

Ambient Temperature

Ambient A/D count

Ground A/D count

Input 1 A/D count

Input 2 A/D count

Input 1 Module Type

Input 2 Module Type

Output 1 Module Type

Output 2 Module Type

Output 3 Module Type

Output 4 Module Type

Test Display

Test Outputs

Open Loop

[Diag]

[Fcty]

Factory Prompt

[PLOC]

[diAg]

[`CAL]

[Fcty]

❸ Press the Mode key µ to step through
the prompts.

❹ Press the Up-arrow key > or the Down-
arrow key < to select one of the prompt
values.

In the Diagnostics Menu only the values of
[dISP], [tout] and [OPLP] can be

changed.

Panel

Diagnostics Calibration

Lockout

p 6.7

p 6.13

p 6.2

[``no] [`YES]

[dISP] [dISP]

[`OFF] [out1]

…

[out4]

[tout] [tout]

[tout]

Figure 6.7 -
The Diagnostics Menu.