Watlow Series 988 - Manual (Page 76)

5.2 WATLOW Series 988 User’s Manual Operation Menus, Chapter 5
MODE
*Local-remote
*Alarm 4 High
*Alarm 4 Low
*Alarm 3 High
*Alarm 2 High
*Alarm 3 Low
Operation Prompt
*Event Input 1 Status
*Event Input 2 Status
*Alarm 2 Low
Enter your settings,
from the controller's
upper display.
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
Event Input (p. 5.4)
Alarms (p. 5.4)
*Auto-tune
MODE
MODE
*Idle Set Point
*Set Point 2
Set Points (p. 5.3)
[`SP2]
[IdSP]
[`SP2]
[`SyS]
[Ei1S]
[Ei2S]
[A2LO]
[A2HI]
[A3LO]
[A3HI]
[A4HI]
[A4LO]
[`AUT]
[`L-r]
Figure 5.2 -
The System Menu.
Operation-System
❸ Select the System Menu, then
press the Mode key µ to step
through the prompts.
❹ Press the Up-arrow key > to step
through the prompt values. The
Down-arrow key < backs through
the values.
…
…
…
[-999]
[A2LO]
[-998]
[A2LO]
[-997]
[A2LO]
[```0]
[A2LO]
*Prompts may not appear, depending
on controller configuration.
TL TL W W W WA A
PROCESS
L1 L2 L3 L4
DEV
% OUT DISPLAY
SERIES 988
MODE
AUTO
MAN
Reaching the System Menu
( p. 5.3 )
( p. 5.4 )
( p. 5.4 )