Calibration menu, P 6.13, Factory-calibration – Watlow Series 988 User Manual

Page 103: Reaching the calibration menu, No] [`yes

WATLOW Series 988 User’s Manual

6.13

Factory Menus, Chapter 6

Reaching the Calibration
Menu

❷ Use the Up-arrow key > or Down-
arrow key < to step through the
Factory Menu to the Calibration Menu
[`CAL].

❶ Begin in the Display Loop, and
press the Up-arrow > and Down-
arrow < key simultaneously for six
seconds until the Setup Menu [`SEt],
then the Factory Menu [fcty]
appear.

❸ Press the Mode key µ to step
through the prompts.

❹ Press the Up-arrow key > or the
Down-arrow key < to select one of
the prompt values.

Refer to Calibrating Watlow Process
Controls for information about the
Calibration Menu.

[PLOC]

[diAg]

[`CAL]

[Fcty]

Panel

Diagnostics Calibration

Lockout

p 6.7

p 6.13

p 6.2

MODE

Diagnostics Prompt

Enter your settings,
from the controller's
upper display.

MODE

[`CAL]

[Fcty]

[A`50]

[A`00]

[``tc]

[a`0H]

[A`20]

[A`15]

[A380]

[A10U]

[A`0U]

[A20A]

[A`4A]

[A`OU]

[A100]

[b`50]

[b`00]

[b`0H]

[b`20]

[b`15]

[b380]

[b10U]

[b`0U

[b20A]

[b`4A]

[b`0U]

[b100]

[1`4`]

[1`20]

[1`0`]

[1`10]

[2`4`]

[2`20]

[2`0`]

[2`10]

[`3LO]

[`3HI]

[`rSt]

[`dFL]

Default

Restore

Factory-Calibration

[``no] [`YES]

[`rSt] [`rSt]

Figure 6.13 -
The Calibration Menu.

CAUTION:
Before attempting to calibrate, make sure
you have the proper equipment called for in
each procedure. The Series 988 is calibrat-
ed and tested before it leaves the factory.
Attempting to calibrate the controller with-
out the proper equipment could result in
damage to property and/or equipment.