Watlow Series 988 - Manual (Page 104)

Factory Menus, Chapter 6 6.14 WATLOW Series 988 User’s Manual
Restore
Restores the original factory calibration values when set to [[` `Y YE ES S]].
This is a simple way to recover from a mistake made while calibrating the
controller.
[`rSt] This prompt always appears.
Default
↓
[``no] [`yes]
[`rSt] [`rSt]
Default
Set the operating parameter defaults to domestic or international
measures.
• [``US] (domestic) sets the controller to °F; rate in minutes; proportional
band in degrees or units; and reset in repeats per minute.
• [``SI] (international) sets the controller to °C; derivative in minutes;
proportional band in percent of span; and integral in minutes per repeat.
[`dFL] This prompt always appears.
Default
↓
[``US] [``sI]
[`dFL] [`dFL]
[`rst]
Factory-Calibration
[`dfl]