Cal2] [rtd2, Setup-input, Calibration offset 2 – Watlow Series 988 User Manual
Page 41: Rtd calibration curve 2

4.14
WATLOW Series 988 User’s Manual
Setup Menus, Chapter 4
Setup-Input
[CAL2]
[rtd2]
Calibration Offset 2
Offset the input 2 signal by a positive or negative value. This allows
you to compensate for lead resistance, sensor errors or other factors.
[CAL2] This prompt appears only if the controller is equipped with input 2
hardware and if [`In2] is not set to [``no] or [`Ei2].
If
Minimum
Default
Max. setting/range
↓
↓
[``°F]
[-999]
…
[```0]
…
[`999]
[`C_F]
[CAL2]
[CAL2]
[CAL2]
(Global Menu)
[``°F]
&
[`r†d]
[-9(9]
…
[``)0]
…
[`9(9]
[`C_F]
[`In2]
[CAL2]
[CAL2]
[CAL2]
(Global Menu)
(Input Menu)
[``°C]
[-555]
…
[```0]
…
[`555]
[`C_F]
[CAL2]
[CAL2]
[CAL2]
(Global Menu)
[``°C]
&
[`r†d]
[-5%5]
…
[``)0]
…
[`5%5]
[`C_F]
[`In2]
[CAL2]
[CAL2]
[CAL2]
(Global Menu)
(Input Menu)
[-999]
…
[```0]
…
[`999]
units
a process input
[CAL2]
[CAL2]
[CAL2]
is selected
RTD Calibration Curve 2
Select the calibration curve for the RTD 2 input. The RTD input uses
either the European (DIN, 0.003850
Ω
/
Ω
/°C) or Japanese (JIS,
0.003916
Ω
/
Ω
/°C) linearization standard.
[rtd2] This prompt appears only on controllers equipped with input 2
hardware and with [`In2] set to [`rtd] or [`r†d].
Default
↓
[`din]
[`JIS]
[rtd2]
[rtd2]