Watlow Series 988 - Manual (Page 67)

4.40 WATLOW Series 988 User’s Manual Setup Menus, Chapter 4
Setup-Global
Event Input 1
Select the effect of closing the event input 1 switch.
• [``no] disables event input 1.
• [`LOC] locks out the front panel keys.
• [`ALr] resets an alarm.
• [A-M] switches the controller to manual mode at the power level set at
[FAIL] (Global Menu) and disables the Auto/Man key.
• [`OFF] turns all control outputs off (de-energize relays).
• [`Pid] switches from PID A to PID B.
• [Actn] selects the opposite control action for output 1 and 2.
• [`rSP] switches to a remote set point.
• [IdSP] switches to an idle or second set point.
[`Ei1] This prompt always appears.
Default
↓
[``no] [`LOC] [`ALr] [A-M] [`OFF] [`Pid] [Actn] [`rsp] [IdSP]
[`Ei1] [`Ei1] [`Ei1] [`Ei1] [`Ei1] [`Ei1] [`Ei1] [`Ei1] [`Ei1]
Event Input 2
Select the effect of closing the event input 2 switch. The selections are
the same as for event input 1.
[`Ei2] This prompt appears only on controllers equipped with hardware
for a second event input (98_ _-_5_ _-_ _ _ _) and with [`In2] set to
[`Ei2].
Default
↓
[``no] [`LOC] [`ALr] [A-M] [`OFF] [`Pid] [Actn] [IdSP]
[`Ei2] [`Ei2] [`Ei2] [`Ei2] [`Ei2] [`Ei2] [`Ei2] [`Ei2]
[`Ei1]
[`Ei2]